Products List
Contact Us

Add:No.110,Liguang New Industrial Zone,Guanlan Street,Longhua New District,Shenzhen

Contact:

Abbie Chow / Shadow Hsiung

Tel:

(0086)755-8379-9309

(0086)755-8297-1183

Fax:

(0086)755-8297-5415/888

Mob:

(0086)178-2039-5231

(0086)135-9029-8041

E-mail:015@kw-link.net

Web: www.cablekw.com

Our service hotline
(0086)755-8297-1183

News

Home > NewsContent

What Happened To The Patch Cable

Edit:Shenzhen KW-LINK Electronic Co.,Ltd      Date:Sep 08, 2017

     The jumper is actually connected to the circuit board (PWB) Two demand point of the metal connection line, because the product design is different; Most jumpers are for the same voltage transmission, also has the reference voltage for the protection circuit ยท For the precise voltage requirements, a little bit of metal wire adjustment produced by the pressure drop will also have a great impact on product performance!Patch Cable
     The "jumper" of the inside of the computer card is a small metal stick (jumper string) embedded in the motherboard, sound card, hard disk, etc., and a small clip (jumper clip) on the metal stick. The function of the jumper is to adjust the on-off relationship of different electrical signals on the equipment, and to adjust the working state of the equipment, such as determining the motherboard voltage, driver's master-slave relationship and so on. Patch Cable
     When the jumper clips are two jumpers at the same time, it indicates that the two jumpers are connected, and if only one or no sleeve is attached, it is disconnected. Adjustment jumper is very important, if the wrong, light is a panic, serious can even burn the entire device, so in the adjustment jumper must read the instructions carefully, check the jumper name, jumper column number and on-off relationship.Patch Cable
     Here refers to the jumper is the copper connection line, by the standard jumper cable and the connection hardware, the jumper cable has two cores to eight cores unequal to the copper core, the connection hardware is two 6-bit or 8-bit module plugs, or they have one or more bare headers. Some jumpers at one end have a module plug on the other end with a 18-bit module slot, or a 100P wiring plug, a MICs, or a module slot. The jumper is used to transfer a variety of links on the wiring rack, which can be used as a wiring rack or equipment connection cable. Modular jumper at both ends of the RJ45 joint, the use of TIA/EIA-568A needle structure, and flexible plug design to prevent loose and die.Patch Cable