Products List
Contact Us

Add:No.110,Liguang New Industrial Zone,Guanlan Street,Longhua New District,Shenzhen

Contact:

Abbie Chow / Shadow Hsiung

Tel:

(0086)755-8379-9309

(0086)755-8297-1183

Fax:

(0086)755-8297-5415/888

Mob:

(0086)178-2039-5231

(0086)135-9029-8041

E-mail:015@kw-link.net

Web: www.cablekw.com

Our service hotline
(0086)755-8297-1183

News

Home > NewsContent

Coaxial Cable Working Principle

Shenzhen KW-LINK Electronic Co.,Ltd | Updated: Jun 15, 2017

    Coaxial cable from the use of points can be divided into baseband coaxial cable and broadband coaxial cable (ie, network coaxial cable and video coaxial cable). Coaxial cable 50Ω baseband cable and 75Ω broadband cable two categories. The baseband cable is subdivided by coaxial cable and coaxial cable. Baseband cable is only used for digital transmission, data rate up to 10Mbps.Coaxial Cable

Coaxial cable (Coaxial Cable) refers to two concentric conductors, and the conductor and the shield and share the same axis of the cable. The most common coaxial cable consists of a copper conductor insulated from the insulating material, and on the outside of the inner layer is another layer of ring conductor and its insulator, and the entire cable is covered by a jacket of polyvinyl chloride or Teflon material The Coaxial Cable

    Coaxial cable from the inside out is divided into four layers: the central copper (single strand of solid or stranded strand), plastic insulator, mesh conductive layer and wire sheath. The central copper wire and the mesh conductive layer form a current loop. Because the central copper wire and mesh conductive layer for the coaxial relationship named. Coaxial cable conduction AC rather than direct current, that is, every second there will be several times the direction of the current reversal. If a high-frequency current is transmitted using a general wire, the wire will correspond to an antenna that emits radio outwards, which forces the power of the signal so that the received signal strength decreases. Coaxial cable design is to solve this problem. The radio from the center wire is isolated by the mesh-like conductive layer, and the mesh-like conductive layer can control the emitted radio by grounding. Coaxial cable also has a problem, that is, if a cable over a large extrusion or twisting deformation, then the central wire and the network between the conductive layer is not always the same distance, which will cause the internal radio waves will be Reflected signal source. This effect reduces the available signal power. In order to overcome this problem, the center wire and mesh conductive layer is added between a layer of plastic insulators to ensure that the distance between them is always the same. This also causes the cable to be stiff and not easy to bend.Coaxial Cable